REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE


  1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY

    Click here

  2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. A01OG19N03

      Using SST, hold the crankshaft pulley.

      SST
      09213-38010
    2. A01OG6S

      Remove the 10 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly and crankshaft angle sensor rotor.

  3. REMOVE ENGINE REAR OIL SEAL


    1. A01OFWEC02
      *a Cut Position

      Using a knife, cut through the lip of the engine rear oil seal.

    2. Using a screwdriver, pry out the engine rear oil seal.

      Note

      After removal, check the crankshaft for damage.

      If it is damaged, smooth the surface with 400-grit sandpaper.

      Tech Tips

      Tape the screwdriver tip before use.