FRONT CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE

1. Click here

   INSTALL TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL

   
   

   1. Apply MP grease to the lip of a new timing chain case or timing chain case oil seal.

   2. 

      *a	Oil Seal Protrusion Height

      Using SST and a hammer, tap in the timing chain case or timing chain case oil seal until its surface is flush with the timing chain cover assembly edge.

      09506-35010

      09223-22010

      Oil Seal Protrusion Height
      0 to 1.0 mm (0 to 0.0394 in.)

      Note:
      

      • Keep the lip free from foreign matter.

      • Do not tap in the timing gear case or timing chain case oil seal at an angle.

      • Do not tap in the timing gear case or timing chain case oil excessively.

2. Click here

   INSTALL CRANKSHAFT TIMING GEAR KEY

   
   

   1. Install the crankshaft timing gear key to the crankshaft groove.

3. Click here

   INSTALL CRANKSHAFT PULLEY

   
   

   1. Align the crankshaft timing gear key with the key groove of the crankshaft pulley, and slide on the crankshaft pulley.

   2. 

      *a	Hold
      *b	Turn

      Using SST, hold the crankshaft pulley and install the crankshaft pulley set bolt.

      09213-38010

      09330-00021

      330 N*m

      3365 kgf*cm

      243 ft.*lbf

4. Click here

   INSTALL V-RIBBED BELT

   Click here

5. Click here

   INSTALL RADIATOR RESERVE TANK ASSEMBLY

   Click here

6. Click here

   INSTALL AIR CLEANER CAP WITH AIR CLEANER HOSE

   Click here

7. Click here

   CONNECT VENTILATION HOSE

   Click here

8. Click here

   INSTALL COOL AIR INTAKE DUCT SEAL

   Click here

9. Click here

   INSTALL V-BANK COVER SUB-ASSEMBLY

   Click here

10. Click here

    INSTALL NO. 1 ENGINE UNDER COVER ASSEMBLY

    Click here