Click here

KNOCK SENSOR INSTALLATION

Click here
Click here

PROCEDURE


  1. Click here

    INSTALL KNOCK CONTROL SENSOR

    Tip:

    Perform "Inspection After Repair" after replacing a knock control sensor.



    1. B0067W0C01
      *a for Bank 2 Sensor 1
      *b for Bank 2 Sensor 2
      *c for Bank 1 Sensor 1
      *d for Bank 1 Sensor 2
      *e Up
      *f 10°
      B00679M Engine Front

      Install the 4 knock control sensors to the cylinder block sub-assembly with the 4 bolts so that the knock control sensor installation position is as shown in the illustration.

      20 N*m 204 kgf*cm 15 ft.*lbf
      Note:

      • Make sure that each knock control sensor is in the correct position.

      • If a knock control sensor has been struck or dropped, replace it.

    2. Connect the 4 knock control sensor connectors.

  2. Click here

    INSTALL CASE SEPARATOR


    1. Install the case separator with the 4 bolts.

      10 N*m 102 kgf*cm 7 ft.*lbf

    2. Connect the fuel pressure sensor connector.

  3. Click here

    INSTALL NO. 4 FUEL PIPE SUB-ASSEMBLY

    Click here

  4. Click here

    INSTALL NO. 2 ENGINE COVER SUB-ASSEMBLY LH

    Click here

  5. Click here

    INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY

    Click here

  6. Click here

    INSTALL INTAKE AIR SURGE TANK ASSEMBLY

    Click here

  7. Click here

    PERFORM INITIALIZATION


    1. Perform "Inspection After Repair" after replacing a knock control sensor.