HORN REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during horn removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly

  • Ultrasonic sensor detection angle (w/ Intuitive Parking Assist System)

  • Ultrasonic sensor detection angle registration (w/ Intuitive Parking Assist System)

  • Intelligent clearance sonar system

  • Simple advanced parking guidance system

Click here

Change grille shutter control modes and/or perform initialization Grille Shutter system

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE HIGH PITCHED HORN ASSEMBLY


    1. A01RKV7

      Disconnect the connector.

    2. Remove the bolt and high pitched horn assembly.

  3. REMOVE LOW PITCHED HORN ASSEMBLY


    1. A01RHRU

      Disconnect the connector.

    2. Remove the bolt and low pitched horn assembly.