REAR LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear light assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear bumper assembly

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

  • Intelligent clearance sonar system

  • Simple advanced parking guidance system

Click here

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR BUMPER ASSEMBLY

    Click here

  2. REMOVE REAR LIGHT ASSEMBLY


    1. w/o Rear Fog Light:


      1. A01RJ6C

        Disconnect the 2 connectors.

    2. w/ Rear Fog Light:


      1. A01RJBM

        Disconnect the 3 connectors.

    3. A01RL42

      Remove the 3 screws.

    4. Disengage the 3 claws and guide to remove the rear light assembly.