CAUTION / NOTICE / HINT
Tech Tips
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
REMOVE TONNEAU COVER ASSEMBLY
REMOVE REAR NO. 1 FLOOR BOARD
REMOVE DECK BOARD RETAINER
REMOVE DECK FLOOR BOX LH (w/o Spare Tire)
REMOVE DECK FLOOR BOX RH (w/o Spare Tire)
for RH Side:
REMOVE REAR DECK FLOOR BOX (w/ Compact Spare Tire)
REMOVE DECK FLOOR BOX LH (w/ Compact Spare Tire)
for LH Side:
REMOVE DECK FLOOR BOX RH (w/ Compact Spare Tire)
for RH Side:
REMOVE DECK FLOOR BOX RH (w/ Full Size Spare Tire)
REMOVE DECK FLOOR BOX LH (w/ Full Size Spare Tire)
for LH Side:
REMOVE DECK TRIM SERVICE HOLE COVER
REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Rear Side)
REMOVE REAR DECK TRIM COVER
REMOVE REAR DOOR SCUFF PLATE
DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP
REMOVE REAR SEAT HEADREST ASSEMBLY (for RH Side)
REMOVE REAR SEAT HEADREST ASSEMBLY (for LH Side)
REMOVE REAR SEAT CENTER HEADREST ASSEMBLY (for RH Side)
DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
REMOVE REAR SEATBACK ASSEMBLY RH (for RH Side)
REMOVE REAR SEATBACK ASSEMBLY LH (for LH Side)
REMOVE REAR SEAT CUSHION ASSEMBLY
REMOVE REAR SEAT CUSHION LOCK HOOK
REMOVE REAR UNDER SIDE COVER
REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY
REMOVE REAR SEAT SIDE GARNISH
REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Side)
REMOVE NO. 1 TONNEAU COVER HOLDER CAP
REMOVE TONNEAU COVER HOOK A
REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY (for LH Side)
REMOVE DECK TRIM SIDE PANEL ASSEMBLY
REMOVE REAR COMBINATION LIGHT COVER
|
Insert Moulding Remover Here |
|
Remove in this Direction |
Using a moulding remover, disengage the 4 claws as shown in the illustration.
|
Remove in this Direction |
Disengage the 2 guides to remove the rear combination light cover as shown in the illustration.
REMOVE REAR COMBINATION LIGHT ASSEMBLY
Disconnect the connector.
|
Protective Tape |
Apply protective tape around the rear combination light assembly as shown in the illustration.
Remove the 2 screws.
| *a | Pin |
| *b | Guide |
|
Remove in this Direction |
Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the 2 pins and 2 guides and separate the rear combination light assembly.
Note
To prevent the rear combination light assembly from falling when disengaging the pins and guides, lightly hold the rear combination light assembly.
Disengage the grommet to remove the rear combination light assembly.