HEADLIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure	Necessary Procedure	Effect/Inoperative Function when Necessary Procedure not Performed	Link
Front bumper assembly	Ultrasonic sensor detection angle Ultrasonic sensor detection angle registration	Intelligent clearance sonar system Simple advanced parking guidance system	Click here
Front bumper assembly	Change grille shutter control modes and/or perform initialization	Grille Shutter system	Click here
No. 1 headlight ECU sub-assembly LH	Synchronize vehicle information Initialize No. 1 headlight ECU sub-assembly LH	Automatic headlight beam level control system	Click here

Note

If the headlight assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.

Tech Tips

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

REMOVE FRONT BUMPER ASSEMBLY

Click here
REMOVE HEADLIGHT ASSEMBLY
1. Remove in this Direction
  
  Disengage the clip to separate the cover as shown in the illustration.
2. Protective Tape
  
  Apply protective tape around the headlight assembly as shown in the illustration.
3. Disconnect the connector.
4. *a Connector Lock Lever
  
  Disconnect in this Direction
  
  Disengage the claw, pull down the connector lock lever as shown in the illustration and disconnect the connector.
5. *a Bolt
  
  *b Screw
  
  Remove the bolt and 3 screws.
6. Remove in this Direction
  
  Remove the headlight assembly as shown in the illustration.

*a	Connector Lock Lever
	Disconnect in this Direction

*a	Bolt
*b	Screw