REAR TURN SIGNAL LIGHT BULB REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE REAR COMBINATION LIGHT COVER

    Click here

  2. SEPARATE REAR COMBINATION LIGHT ASSEMBLY


    1. A01RL8LC01
      B004PFI Protective Tape

      Apply protective tape around the rear combination light assembly as shown in the illustration.

    2. A01RHR9

      Remove the 2 screws.

    3. A01RHFMC01
      *a Pin
      *b Guide
      B004PI4 Remove in this Direction

      Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the 2 pins and 2 guides and separate the rear combination light assembly.

      Note

      To prevent the rear combination light assembly from falling when disengaging the pins and guides, lightly hold the rear combination light assembly.

  3. REMOVE REAR TURN SIGNAL LIGHT BULB


    1. A01RJWRC01
      B004PI4 Remove in this Direction

      Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to disconnect them as a unit.

    2. Remove the rear turn signal light bulb from the rear combination light socket and wire sub-assembly.

  4. INSTALL REAR TURN SIGNAL LIGHT BULB


    1. Install the rear turn signal light bulb to the rear combination light socket and wire sub-assembly.

    2. A01RLDCC01
      B004PI4 Install in this Direction

      Turn the rear combination light socket and wire sub-assembly with the rear turn signal light bulb as shown in the illustration to connect them as a unit.

  5. INSTALL REAR COMBINATION LIGHT ASSEMBLY


    1. A01RJGVC01
      *a Pin
      *b Guide
      B004PI4 Install in this Direction

      Engage the 2 guides and 2 pins to temporarily install the rear combination light assembly as shown in the illustration.

    2. Install the rear combination light assembly with the 2 screws.

    3. Remove the protective tape.

  6. INSTALL REAR COMBINATION LIGHT COVER

    Click here