BACK DOOR OPENER SWITCH INSPECTION

PROCEDURE


  1. INSPECT BACK DOOR OPENER SWITCH ASSEMBLY


    1. Check the operation of the opener switch.


      1. B004P3SC05
        *a

        Component without harness connected

        (Back Door Opener Switch Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        R2-2 (E) - R2-3 (UL) Back door opener switch not pushed 10 kΩ or higher
        R2-2 (E) - R2-3 (UL) Back door opener switch pushed Below 1 Ω

        If the result is not as specified, replace the back door opener switch assembly.

    2. Check the operation of the lock switch. (w/ Entry and Start System)


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        R2-1 (L) - R2-2 (E) Back door lock switch not pushed 10 kΩ or higher
        R2-1 (L) - R2-2 (E) Back door lock switch pushed Below 1 Ω

        If the result is not as specified, replace the back door opener switch assembly.