OUTER REAR VIEW MIRROR GLASS REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE OUTER MIRROR


    1. B004Q2OC01
      B004PFI Protective Tape

      Apply protective tape to the areas shown in the illustration.

    2. Push the upper part of the mirror surface and tilt it.

    3. Using a moulding remover, disengage the 2 claws on the lower part of the outer mirror as shown in the illustration.

      Note

      Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.

    4. Push the lower part of the mirror surface and tilt it.

    5. B004Q3FC01
      B004PFI Protective Tape

      Using a moulding remover, disengage the 2 claws on the upper part of the outer mirror as shown in the illustration.

      Note

      Do not push the outer mirror with excessive force. Doing so may cause the actuator to come off or break the mirror surface.

    6. w/o Blind Spot Monitor System:


      1. Disconnect the connector to remove the outer mirror.

    7. w/ Blind Spot Monitor System:


      1. B004Q10

        Disconnect the connector.

      2. B004PR5C01
        B004PI4 Push in this Direction

        Disengage the claw as shown in the illustration.

      3. B004PSH

        Disengage the clamp.

      4. Disconnect the connector to remove the outer mirror.