SLIDING ROOF SWITCH ASSEMBLY INSPECTION

PROCEDURE


  1. INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY)


    1. B004Q82C06
      *a

      Component without harness connected

      (Sliding Roof Switch (Map Light Assembly))

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      O4-4 (UP) - O4-11 (GND) UP switch pressed Below 100 Ω
      O4-4 (UP) - O4-11 (GND) UP switch not pressed 1 kΩ or higher
      O4-3 (DOWN) - O4-11 (GND) DOWN switch pressed Below 100 Ω
      O4-3 (DOWN) - O4-11 (GND) DOWN switch not pressed 1 kΩ or higher
      O4-6 (OPN) - O4-11 (GND) OPEN switch pressed Below 100 Ω
      O4-6 (OPN) - O4-11 (GND) OPEN switch not pressed 1 kΩ or higher
      O4-5 (CLS) - O4-11 (GND) CLOSE switch pressed Below 100 Ω
      O4-5 (CLS) - O4-11 (GND) CLOSE switch not pressed 1 kΩ or higher

      If the result is not as specified, replace the sliding roof switch (map light assembly).