SLIDING ROOF HOUSING DISASSEMBLY

PROCEDURE


  1. REMOVE SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY


    1. A01RIS7C01
      B004PI4 Remove in this Direction

      Remove the bolt.

    2. Disengage the 2 guides as shown in the illustration to remove the map light bracket.

    3. A01RK5K

      Remove the 2 bolts and sliding roof drive gear sub-assembly.

  2. REMOVE SUNSHADE TRIM SUB-ASSEMBLY


    1. A01RHLBC01
      B004PI4 Remove in this Direction (1)
      B004OIV Remove in this Direction (2)

      Remove the screw.

    2. Move the sliding roof piece sub-assembly LH in the direction indicated by the arrow (1) shown in the illustration to disengage the guide (A).

    3. Move the sliding roof piece sub-assembly LH in the direction indicated by the arrow (2) shown in the illustration to disengage the 2 guides (B) and remove the sliding roof piece sub-assembly LH.

      Tech Tips

      Use the same procedure for the RH side.

    4. A01RH2WC01
      B004PI4 Remove in this Direction

      Remove the rear sliding roof sunshade stopper as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side.

    5. A01RLGTC01
      B004PI4 Remove in this Direction

      Slide and remove the sunshade trim sub-assembly as shown in the illustration.

  3. REMOVE SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY

    Note

    Do not disassemble the sliding roof drive cable sub-assembly except when replacing it.


    1. Using a screwdriver, disengage the 2 claws as shown in the illustration.

      A01RKQSC01
      *a Protective Tape - -
      B004PI4 Remove in this Direction - -

      Tech Tips

      Tape the screwdriver tip before use.

    2. A01RJRBC01
      B004PI4 Remove in this Direction

      Slide and remove the rear roof drip channel as shown in the illustration.

    3. A01RIV3C01
      A01VCE6 Hold Position

      Hold down the roof wind deflector panel sub-assembly.

    4. A01RJG3C01
      *a Protective Tape
      A01VCE6 Push Position
      B004PI4 Remove in this Direction

      Using a screwdriver, slide the sliding roof drive cable LH as shown in the illustration to remove it.

      Tech Tips


      • Tape the screwdriver tip before use.

      • Use the same procedure for the RH side.