SLIDING ROOF HOUSING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof glass sub-assembly, sliding roof housing sub-assembly, sliding roof drive gear assembly or sliding roof drive cable sub-assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Sliding roof ECU (sliding roof drive gear sub-assembly)

  • Sliding roof glass sub-assembly

  • Sliding roof drive cable sub-assembly

  • Sliding roof housing sub-assembly

 Initialize Sliding Roof System

  • Auto operation function

  • Jam protection function

  • Key-off operation function

  • Key-linked function

  • Wireless transmitter-linked function

  • Sliding roof open warning function

Click here

Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

PROCEDURE


  1. REMOVE SLIDING ROOF SIDE GARNISH LH


    1. B004OXY

      Disengage the 2 claws to remove the sliding roof side garnish LH.

  2. REMOVE SLIDING ROOF SIDE GARNISH RH

    Tech Tips

    Use the same procedure as for the LH side.

  3. REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY


    1. Move the sliding roof glass sub-assembly to the fully closed position.

    2. Using a T25 "TORX" socket wrench, remove the 4 screws and sliding roof glass sub-assembly.

      B004PH2

      Note

      To prevent the sliding roof glass sub-assembly and sliding roof drive gear sub-assembly from becoming misaligned, move the sliding roof glass sub-assembly (sliding roof drive cable sub-assembly) to the fully closed position before removing.

  4. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

    Click here

  5. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  6. DISCONNECT SLIDING ROOF DRAIN HOSE ASSEMBLY LH


    1. B004PIY

      Disengage the claw and disconnect the sliding roof drain hose assembly LH.

  7. DISCONNECT SLIDING ROOF DRAIN HOSE ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  8. DISCONNECT SLIDING ROOF DRAIN HOSE

    Tech Tips


    • Use the same procedure as for the sliding roof drain hose assembly LH.

    • Use the same procedure for both sliding roof drain hoses.

  9. REMOVE SLIDING ROOF HOUSING ASSEMBLY


    1. Remove the 4 bolts, 6 nuts and sliding roof housing assembly.

      B004QBE