POWER WINDOW REGULATOR MOTOR(for Front Door) INSPECTION

PROCEDURE

1. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY LH

   
   
   1. 

      *A	for LHD
      *B	for RHD
      *a	Component without harness connected (Power Window Regulator Motor Assembly LH)
      *b	Clockwise
      *c	Counterclockwise
      *d	Motor gear

      Connect a positive (+) auxiliary battery lead to connector terminal 2.

      Note

      Do not connect a positive (+) auxiliary battery lead to any terminals other than terminal 2 to avoid damaging the pulse sensor inside the motor.

   2. Connect a negative (-) auxiliary battery lead to connector terminals 1 and 7 or 10.

   3. Check that the motor gear rotates smoothly as follows:

      OK

      Measurement Condition Specified Condition Connect a positive (+) auxiliary battery lead to J2-2 (B), connect a negative (-) auxiliary battery lead to J2-1 (GND), and keep them connected for 3 seconds or more. With J2-2 (B) and J2-1 (GND) connected, connect a negative (-) auxiliary battery lead to J2-10 (UP). Motor gear rotates clockwise Connect a positive (+) auxiliary battery lead to J2-2 (B), connect a negative (-) auxiliary battery lead to J2-1 (GND), and keep them connected for 3 seconds or more. With J2-2 (B) and J2-1 (GND) connected, connect a negative (-) auxiliary battery lead to J2-7 (DOWN). Motor gear rotates counterclockwise

      
      

      • If the result is not as specified, replace the power window regulator motor assembly LH.

      CAUTION:

      Initialize the power window control system after installing the power window regulator motor and regulator assembly.

2. INSPECT POWER WINDOW REGULATOR MOTOR ASSEMBLY RH

   
   
   1. 

      *a	Component without harness connected (Power Window Regulator Motor Assembly RH)
      *b	Clockwise
      *c	Counterclockwise
      *d	Motor gear

      Connect a positive (+) auxiliary battery lead to connector terminal 2.

      Note

      Do not connect a positive (+) auxiliary battery lead to any terminals other than terminal 2 to avoid damaging the pulse sensor inside the motor.

   2. Connect a negative (-) auxiliary battery lead to connector terminals 1 and 7 or 10.

   3. Check that the motor gear rotates smoothly as follows:

      OK

      Measurement Condition Specified Condition Connect the positive (+) auxiliary battery lead to I2-2 (B), connect a negative (-) auxiliary battery lead to I2-1 (GND), and keep them connected for 3 seconds or more. With I2-2 (B) and I2-1 (GND) connected, connect a negative (-) auxiliary battery lead to I2-10 (UP). Motor gear rotates counterclockwise Connect a positive (+) auxiliary battery lead to I2-2 (B), connect a negative (-) auxiliary battery lead to I2-1 (GND), and keep them connected for 3 seconds or more. With I2-2 (B) and I2-1 (GND) connected, connect a negative (-) auxiliary battery lead to I2-7 (DOWN). Motor gear rotates clockwise

      
      

      • If the result is not as specified, replace the power window regulator motor assembly RH.

      CAUTION:

      Initialize the power window control system after installing the power window regulator motor and regulator assembly.