FRONT EVAPORATOR TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL NO. 1 COOLER THERMISTOR


    1. A01RJ9AC03
      *a Fixed Part
      *b Sensor Part

      Install the No. 1 cooler thermistor as shown in the illustration.

      Installation Position
      Part Length
      A 50.0 mm (1.97 in.)
      B 67.9 mm (2.67 in.)
      C 168.3 mm (6.63 in.)

      Note


      • Be sure to insert the No. 1 cooler thermistor only once because reinserting it into the same position will not allow it to be firmly secured.

      • When reusing the No. 1 cooler evaporator sub-assembly, insert the No. 1 cooler thermistor one row next to the one that has been used previously (X in the illustration).

      • After inserting the No. 1 cooler thermistor, do not apply excessive force to the wire.

      • Directly insert the No. 1 cooler thermistor until the edge of the plastic case "a" comes into contact with the No. 1 cooler evaporator sub-assembly "b".

  2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

    Click here

  3. INSTALL COOLER EXPANSION VALVE

    Click here

  4. INSTALL HEATER RADIATOR UNIT SUB-ASSEMBLY

    Click here

  5. INSTALL HEATER CLAMP

    Click here

  6. INSTALL HEATER GROMMET

    Click here

  7. INSTALL NO. 2 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY

    Click here

  8. INSTALL AIR CONDITIONING HARNESS ASSEMBLY

    Click here

  9. INSTALL BLOWER ASSEMBLY

    Click here