AMBIENT TEMPERATURE SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ambient temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly

  • Ultrasonic sensor detection angle (w/ TOYOTA Parking Assist-sensor System)

  • Ultrasonic sensor detection angle registration (w/ TOYOTA Parking Assist-sensor System)

  • Intelligent clearance sonar system

  • Simple advanced parking guidance system

Click here

Change grille shutter control modes and/or perform initialization (w/ Exhaust Heat Recirculation System) Grille Shutter system

Click here

PROCEDURE


  1. REMOVE RADIATOR SUPPORT OPENING COVER (w/o Exhaust Heat Recirculation System)

    Click here

  2. REMOVE FRONT BUMPER ASSEMBLY (w/ Exhaust Heat Recirculation System)

    Click here

  3. REMOVE THERMISTOR ASSEMBLY (w/o Exhaust Heat Recirculation System)


    1. A01RKJC

      Disengage the clamp.

    2. Disconnect the connector to remove the thermistor assembly.

  4. REMOVE THERMISTOR ASSEMBLY (w/ Exhaust Heat Recirculation System)


    1. A01RJXF

      Disengage the clamp.

    2. Disconnect the connector to remove the thermistor assembly.