FRONT SEAT INNER BELT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front seat inner belt assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:


  • A01VBPZ

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)

    Click here

  2. REMOVE FRONT SEAT ASSEMBLY (for Power Seat)

    Click here

  3. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)


    1. Disconnect each connector.

    2. Disengage each clamp.

    3. for Manual Seat:


      1. A01RJTO

        Disengage the 2 clamps.

      2. Remove the nut and front seat inner belt assembly.

    4. A01RH5O

      for Power Seat:


      1. Disengage the 2 clamps.

      2. Remove the nut and front seat inner belt assembly.

    5. A01RI07C02
      B004PI4 Remove in this Direction

      Remove the front seat belt anchor plate as shown in the illustration.

  4. REMOVE FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)


    1. Disconnect each connector.

    2. Disengage each clamp.

    3. A01RJMC

      Disengage the clamp.

    4. Remove the nut and front seat inner belt assembly.

    5. A01RHFSC02
      B004PI4 Remove in this Direction

      Remove the front seat belt anchor plate as shown in the illustration.