OCCUPANT DETECTION SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during occupant detection sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:


  • B004QZ9

    Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  2. REMOVE FRONT SEAT INNER BELT ASSEMBLY

    Click here

  3. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  4. REMOVE NO. 1 RECLINING HINGE COVER

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  5. REMOVE RECLINING ADJUSTER RELEASE HANDLE

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  6. REMOVE FRONT SEAT CUSHION SHIELD

    Click here

  7. REMOVE FRONT SEAT INNER CUSHION SHIELD

    Click here

  8. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  9. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

    Tech Tips

    Use the same procedure as for the driver seat.

    Click here

  10. REMOVE OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)


    1. Using a screwdriver, disengage the 13 claws and remove the occupant detection sensor (separate type front seat cushion pad) from the separate type front seat cushion cover as shown in the illustration.

      A01RKCGC01
      *a Screwdriver - -