FRONT SEAT CUSHION HEATER(for Manual Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat cushion heater assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system
Simple intelligent parking assist system
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Front passenger seat*1 Zero point calibration (Occupant classification system)

  • Occupant classification system

  • Passenger airbag ON/OFF indicator

  • Airbag system (Front passenger side)

  • Seat belt warning system (Front passenger)

Click here

*1: w/ Occupant Classification System

CAUTION:


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for LHD vehicles.

  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

    Click here

  3. REMOVE VERTICAL ADJUSTING HANDLE (for Driver Side)

    Click here

  4. REMOVE NO. 1 RECLINING HINGE COVER

    Click here

  5. REMOVE RECLINING ADJUSTER RELEASE HANDLE

    Click here

  6. REMOVE SEAT ADJUSTER COVER CAP (for Driver Side)

    Click here

  7. REMOVE FRONT SEAT CUSHION SHIELD (for Driver Side)

    Click here

  8. REMOVE FRONT SEAT INNER CUSHION SHIELD (for Driver Side)

    Click here

  9. REMOVE FRONT SEAT CUSHION SHIELD (for Front Passenger Side)

    Click here

  10. REMOVE FRONT SEAT INNER CUSHION SHIELD (for Front Passenger Side)

    Click here

  11. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click here

  12. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

    Click here

  13. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

    Click here

  14. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY


    1. B004P8E

      Remove the 15 tag pins and front seat cushion heater assembly from the separate type front seat cushion cover.