PRE-CRASH SAFETY SYSTEM WARNING BUZZER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during skid control buzzer removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

PROCEDURE


  1. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

    Click here

  2. REMOVE SKID CONTROL BUZZER


    1. A01VBT0

      Disengage the clamp.

    2. Disconnect the connector to remove the skid control buzzer.

      Note

      If the skid control buzzer has been struck or dropped, replace it with a new one.