SRS SEAT CUSHION AIRBAG ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat cushion airbag assembly RH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system
Simple intelligent parking assist system
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

Removal/installation of the front passenger seat*1 Zero point calibration (Occupant classification system)

  • Occupant classification system

  • Passenger airbag ON/OFF indicator

  • Airbag system (Front passenger side)

  • Seat belt warning system (Front passenger)

Click here

*1: w/ Occupant Classification System

CAUTION:


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

A01VCY0

Note

If the front seat cushion airbag assembly RH has been deployed, replace the front seat cushion airbag assembly RH, front seat adjuster assembly RH, separate type front seat cushion pad and separate type front seat cushion cover with the necessary parts in accordance with the extent of the collision damage.

Click here

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

    Click here

  2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER

    Tech Tips

    Use the same procedure as for the LH side.

    Click here

  3. REMOVE NO. 1 RECLINING HINGE COVER

    Tech Tips

    Use the same procedure as for the LH side.

    Click here

  4. REMOVE RECLINING ADJUSTER RELEASE HANDLE RH

    Tech Tips

    Use the same procedure as for the LH side.

    Click here

  5. REMOVE FRONT SEAT CUSHION SHIELD RH

    Click here

  6. REMOVE FRONT SEAT INNER CUSHION SHIELD RH

    Click here

  7. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

    Click here

  8. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD RH

    Tech Tips

    Use the same procedure as for the LH side.

    Click here

  9. REMOVE FRONT SEAT CUSHION AIRBAG ASSEMBLY RH

    CAUTION:

    When storing the front seat cushion airbag assembly RH, keep the airbag deployment side facing upward.

    A01RLL3C01
    B004PFI Deployment Side

    1. A01RKLE

      Disengage the 2 clamps and claw.

      Tech Tips

      Disengage the clamps first.

    2. Remove the 3 nuts.

      Note


      • The nuts must not be reused.

      • Make sure that the front seat adjuster assembly RH is not deformed. If it is, replace it with a new one.

    3. A01RHJ4

      Pass the airbag wire harness through the hole to remove the front seat cushion airbag assembly RH.