REAR AIRBAG SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear airbag sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system
Simple intelligent parking assist system
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

PROCEDURE


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing.

    Click here

    B004R04

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

    B004PKN

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE REAR SEATBACK ASSEMBLY

    for LH Side: Click here

    for RH Side: Click here

  4. REMOVE REAR DOOR SCUFF PLATE

    Click here

  5. REMOVE REAR UNDER SIDE COVER LH (for LH Side)

    Click here

  6. REMOVE REAR UNDER SIDE COVER RH (for RH Side)

    Click here

  7. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

    Tech Tips

    Disconnect the rear door opening trim weatherstrip to the extent that allows the removal of the rear seat side garnish.

  8. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY

    Click here

  9. REMOVE REAR SEAT SIDE GARNISH

    Click here

  10. REMOVE REAR AIRBAG SENSOR


    1. Check that the power switch is off.

    2. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.

      B004PKN

    3. Disconnect the connector from the rear airbag sensor.

      Note

      When disconnecting any airbag connector, take care not to damage the airbag wire harness.


      1. Push down the white housing lock and slide the yellow CPA. (At this time, the connector cannot be disconnected yet.)

        B004QVFC18
        *a White Housing Lock *b Yellow CPA
        *c Slide *d Push

      2. Push down the white housing lock again and disconnect the connector.

        Note

        Do not push down the part (A) shown in the illustration when disconnecting the connector.

    4. B004PY5

      Remove the bolt and disengage the claw to remove the rear airbag sensor.

    5. Check that the position of the white housing lock is as shown in the illustration.

      B004Q2WC01
      *a Correct *b Incorrect