BACK DOOR LOCK INSPECTION

PROCEDURE


  1. INSPECT BACK DOOR LOCK ASSEMBLY


    1. Check the operation of the door lock motor.


      1. B004PAQC08
        *a

        Component without harness connected

        (Back Door Lock Assembly)
        *b Close (Lock)
        *c Open (Unlock)

        Move the door lock to the close (lock) position.

      2. Apply auxiliary battery voltage and check the operation of the door lock motor.

        OK
        Tester Connection Result

        R14-1 (ACT+) - Auxiliary battery positive (+)

        R14-2 (ACT-) - Auxiliary battery negative (-)

        		 Back door lock motor open (unlock) operation

        If the result is not as specified, replace the back door lock assembly.

    2. Check the operation of the back door courtesy switch.


      1. Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        R14-2 (ACT-) - R14-3 (D+) Closed (Locked) 10 kΩ or higher
        R14-2 (ACT-) - R14-3 (D+) Open (Unlocked) Below 1 Ω

        If the result is not as specified, replace the back door lock assembly.