REAR BUMPER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear bumper removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear bumper assembly (w/ TOYOTA Parking Assist-sensor System)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

  • Intelligent clearance sonar system

  • Simple advanced parking guidance system

Click here

PROCEDURE


  1. REMOVE REAR COMBINATION LIGHT COVER LH

    Click here

  2. REMOVE REAR COMBINATION LIGHT COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  3. REMOVE REAR BUMPER ASSEMBLY


    1. A01RLCFC01
      B004PFI Protective Tape

      Apply protective tape around the rear bumper assembly as shown in the illustration.

    2. A01RHGQ

      Remove the clip.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. A01RLW4

      Remove the 9 clips.

    4. A01RH3L

      Remove the 4 screws.

    5. A01RHLEC01
      B004PI4 Remove in this Direction

      Disengage the 5 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. A01RIFDC01
      B004PI4 Remove in this Direction

      Disengage the 2 claws as shown in the illustration.

    7. Disconnect the connector to remove the rear bumper assembly.