FRONT BUMPER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front bumper removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly

  • Ultrasonic sensor detection angle (w/ TOYOTA Parking Assist-sensor System)

  • Ultrasonic sensor detection angle registration (w/ TOYOTA Parking Assist-sensor System)

  • Intelligent clearance sonar system

  • Simple advanced parking guidance system

Click here

Change grille shutter control modes and/or perform initialization (w/ Exhaust Heat Recirculation System) Grille Shutter system

Click here

Tech Tips

When the front bumper is damaged or deformed due to an accident or contact with other objects, etc., or the bumper installation area on the body is repaired, it is necessary to perform millimeter wave radar sensor adjustment.

Click here

PROCEDURE


  1. PRECAUTION (w/ Exhaust Heat Recirculation System)


    1. Change the grille shutter control mode to maintenance mode.

      Click here

      Note

      Make sure to change the grille shutter control mode to maintenance mode to prevent the grill shutter from opening or closing when the power switch is off.

  2. REMOVE RADIATOR SUPPORT OPENING COVER


    1. B004PQX

      Remove the 5 clips.

    2. B004P8KC01
      B004PI4 Remove in this Direction (1)
      B004OIV Remove in this Direction (2)

      Disengage the 2 guides and remove the radiator support opening cover as shown in the illustration.

  3. REMOVE FRONT BUMPER ASSEMBLY


    1. B004OJRC01
      B004PFI Protective Tape

      Apply protective tape around the front bumper assembly.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    2. B004QVHC01
      *1 Pin Hold Clip
      *a 90 deg
      B004PI4 Remove in this Direction (1)
      B004OIV Remove in this Direction (2)

      Using a screwdriver, turn the pin 90 degrees and remove the 2 pin hold clips.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    3. B004QOC

      Remove the screw.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. B004Q8O

      Remove the 10 screws.

    5. B004OLWC01
      B004QOG Place Hand Here
      B004PI4 Remove in this Direction

      Disengage the 4 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    6. w/ Fog Light:


      1. B004PTZC01
        B004PI4 Remove in this Direction

        Pull back the side of the front bumper assembly and disconnect the connector.

        Note

        Do not apply excessive force when pulling back the front bumper assembly.

        Tech Tips

        Use the same procedure for the RH side and LH side.

    7. B004QXHC01
      *A w/ TOYOTA Parking Assist-sensor System
      *B w/ Toyota Safety Sense

      w/ TOYOTA Parking Assist-sensor System:


      1. Disconnect the connector.

    8. w/ Toyota Safety Sense:


      1. Disconnect the connector.

    9. B004P96

      Remove the 4 bolts.

    10. B004ONOC01
      B004PI4 Remove in this Direction

      Remove the 2 clips and front bumper assembly as shown in the illustration.