REAR DOOR BELT MOULDING INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY

   
   

   1. 

      Install in this Direction

      Engage the 8 claws as shown in the illustration to install a new rear door belt moulding assembly.

2. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

3. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

4. INSTALL REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

   Click here

5. CONNECT REAR DOOR WEATHERSTRIP

   Click here

6. INSTALL REAR DOOR GLASS RUN

   Click here

7. INSTALL REAR DOOR NO. 2 SERVICE HOLE COVER

   Click here

8. INSTALL REAR DOOR PANEL PROTECTOR

   Click here

9. INSTALL REAR DOOR SERVICE HOLE COVER

   Click here

10. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP WITH REAR DOOR NO. 2 VENT SEAL

    Click here

11. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

12. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL

    Click here

13. INSTALL REAR ARMREST ASSEMBLY

    Click here

14. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

    Click here

15. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

16. INITIALIZE POWER WINDOW CONTROL SYSTEM

    Click here

17. INSPECT POWER WINDOW OPERATION

    Click here