NAVIGATION RECEIVER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during navigation receiver assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

PROCEDURE


  1. PRECAUTION

    Note

    After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

    Click here

  3. REMOVE INSTRUMENT PANEL FINISH PANEL END RH (for LHD)

    Click here

  4. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

    Click here

  5. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET


    1. B004OX2

      Remove the 4 bolts.

    2. B004P2WC01
      B004PI4 Remove in this Direction

      Pull the navigation receiver assembly with bracket toward the rear of the vehicle and disengage the 2 guides.

    3. Disconnect each connector and remove the navigation receiver assembly with bracket.

  6. REMOVE NO. 1 RADIO BRACKET


    1. B004QHEC01
      *A for Type A
      *B for Type B

      Remove the 3 screws and No. 1 radio bracket.

  7. REMOVE NO. 2 RADIO BRACKET


    1. B004QFCC01
      *A for Type A
      *B for Type B

      Remove the 3 screws and No. 2 radio bracket.

  8. REMOVE NAVIGATION RECEIVER ASSEMBLY