NAVIGATION SYSTEM(for Radio and Display Type) AVC-LAN Circuit

DESCRIPTION

Each unit of the navigation system connected to the AVC-LAN (communication bus) transmits switch signals through the AVC-LAN.

If a short to +B or short to ground occurs in the AVC-LAN, the navigation system will not function normally because communication is not possible.

WIRING DIAGRAM

B004P40E31
*1 Radio and Display Receiver Assembly
*2 Stereo Component Amplifier Assembly
*3 AVC-LAN Communication Line

CAUTION / NOTICE / HINT

Tech Tips

The radio and display receiver assembly is the master unit.

PROCEDURE


  1. INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY


    1. Remove the radio and display receiver assembly.

      Click here

    2. B004QGKC39
      *a

      Component without harness connected

      (Radio and Display Receiver Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F31-7 (TX1+) - F31-8 (TX1-) Always 60 to 80 Ω
      Result
      Proceed to
      OK
      NG

    NG

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (AVC-LAN CIRCUIT)


    1. Disconnect the F31 radio and display receiver assembly connector.

    2. Disconnect the F61 stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F31-7 (TX1+) - F61-8 (TX+) Always Below 1 Ω
      F31-8 (TX1-) - F61-7 (TX-) Always Below 1 Ω
      F31-7 (TX1+) or F61-8 (TX+) - Body ground Always 10 kΩ or higher
      F31-8 (TX1-) or F61-7 (TX-) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT MALFUNCTIONING PARTS


    1. Disconnect and reconnect each slave unit one by one until the master unit returns to normal.

      Tech Tips


      • Check all slave units.

      • If disconnecting a slave unit causes the master unit to return to normal, the slave unit is defective and should be replaced.

      OK
      Master unit returns to normal.
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE MALFUNCTIONING PARTS

    NG

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Click here