NAVIGATION SYSTEM(for Radio and Display Type) Mute Signal Circuit between Radio Receiver and Telematics Transceiver

DESCRIPTION

The telematics transceiver sends a mute signal to the radio and display receiver assembly.

The radio and display receiver assembly controls the volume according to the mute signal from the telematics transceiver.

WIRING DIAGRAM

B004QDBE18
*1 MUTE
*2 Radio and Display Receiver Assembly
*3 Telematics Transceiver

CAUTION / NOTICE / HINT

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.

Click here

PROCEDURE


  1. INSPECT TELEMATICS TRANSCEIVER


    1. B004QP1C33
      *a

      Component with harness connected

      (Telematics Transceiver)

      Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      F36-17 (MUTE) - Body ground

      Power switch on (ACC)

      Audio system playing

      → Emergency call mode

      2.0 V or higher

      → Below 1 V
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

  2. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - TELEMATICS TRANSCEIVER)


    1. Disconnect the F32 radio and display receiver assembly connector.

    2. Disconnect the F36 telematics transceiver connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      F32-8 (TMUT) - F36-17 (MUTE) Always Below 1 Ω
      F32-8 (TMUT) or F36-17 (MUTE) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. INSPECT RADIO AND DISPLAY RECEIVER ASSEMBLY


    1. Disconnect the F36 telematics transceiver connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      F36-17 (MUTE) - Body ground Power switch on (ACC) 2.0 V or higher
      Result
      Proceed to
      OK
      NG

    OK

    REPLACE TELEMATICS TRANSCEIVER Click here

    NG

    REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY Click here