NOISE FILTER REMOVAL

PROCEDURE


  1. REMOVE TONNEAU COVER ASSEMBLY

    Click here

  2. REMOVE REAR NO. 1 FLOOR BOARD

    Click here

  3. REMOVE DECK BOARD RETAINER

    Click here

  4. REMOVE DECK FLOOR BOX LH (w/o Spare Tire)

    Click here

  5. REMOVE REAR DECK FLOOR BOX (w/ Compact Spare Tire)

    Click here

  6. REMOVE DECK FLOOR BOX LH (w/ Compact Spare Tire)

    Click here

  7. REMOVE DECK FLOOR BOX RH (w/ Full Size Spare Tire)

    Click here

  8. REMOVE DECK FLOOR BOX LH (w/ Full Size Spare Tire)

    Click here

  9. REMOVE DECK TRIM SERVICE HOLE COVER

    Click here

  10. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for Rear Side)

    Click here

  11. REMOVE REAR DECK TRIM COVER

    Click here

  12. REMOVE REAR SEAT HEADREST ASSEMBLY (for LH Side)

    Click here

  13. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

    Click here

  14. REMOVE REAR SEATBACK ASSEMBLY LH

    Click here

  15. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  16. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  17. REMOVE REAR DOOR SCUFF PLATE LH

    Click here

  18. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH

    Click here

  19. REMOVE REAR UNDER SIDE COVER LH

    Click here

  20. REMOVE REAR SEATBACK HINGE SUB-ASSEMBLY LH

    Click here

  21. REMOVE REAR SEAT SIDE GARNISH LH

    Click here

  22. REMOVE LUGGAGE HOLD BELT STRIKER ASSEMBLY (for LH Side)

    Click here

  23. REMOVE NO. 1 TONNEAU COVER HOLDER CAP (for LH Side)

    Click here

  24. REMOVE TONNEAU COVER HOOK A (for LH Side)

    Click here

  25. REMOVE NO. 1 LUGGAGE COMPARTMENT LIGHT ASSEMBLY

    Click here

  26. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH

    Click here

  27. REMOVE ROOF SIDE INNER GARNISH ASSEMBLY LH

    Click here

  28. REMOVE RADIO SETTING CONDENSER

    Note

    When the terminal cover is removed, the radio setting condenser must be replaced because the terminal cover and condenser are supplied as a set.


    1. A01RIGG

      Remove the bolt.

    2. Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.

    3. A01RK0G

      Using a screwdriver, disengage the 3 claws and remove the terminal cover with wire harness from the condenser.

    4. A01RLHO

      Using a screwdriver, bend back and break off the claw as shown in the illustration.

    5. Remove the terminal cover from the wire harness.

      Note


      • Make sure to hold the crimping side of the terminal when disconnecting the wire harness from the terminal cover.

      • Make sure not to bend the exposed wire when disconnecting the wire harness from the terminal cover.

      • Check for deformation of the terminal after the wire harness has been removed from the terminal cover.