STEREO COMPONENT AMPLIFIER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during stereo component amplifier assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

*1: When performing learning using the GTS.

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

A01VBPZ

Click here

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  2. REMOVE AUDIO AMPLIFIER COVER


    1. A01RKU3C01
      B004PI4 Remove in this Direction (1)
      B004OIV Remove in this Direction (2)

      Pull the audio amplifier cover in the direction indicated by the arrow (1) shown in the illustration to disengage the 2 clips.

    2. Pull the audio amplifier cover in the direction indicated by the arrow (2) shown in the illustration to disengage the guide and remove the audio amplifier cover.

  3. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY


    1. A01RH4Q

      Disengage the clamp.

    2. Disconnect the 2 connectors.

    3. A01RL2H

      Remove the 2 bolts and remove the stereo component amplifier assembly.