FRONT DOOR SPEAKER REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

    Click here

  2. REMOVE FRONT ARMREST ASSEMBLY

    Click here

  3. REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Driver Side)

    Click here

  4. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL (for Front Passenger Side)

    Click here

  5. REMOVE COURTESY LIGHT ASSEMBLY

    Click here

  6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  7. REMOVE FRONT NO. 1 SPEAKER ASSEMBLY


    1. A01RJKQ

      Disconnect the connector.

    2. A01RLGJ

      Using a drill bit with a diameter of less than 5 mm (0.197 in.), drill out the 3 rivet heads.

      Note


      • Do not touch the speaker cone.

      • Do not drill the rivet at an angle as this will cause damage to the drill and rivet installation hole. Line up the drill with the rivet, and carefully drill out the rivet head.

      • Be careful as the drilled rivet will be very hot.

    3. Continue drilling and push out the remaining rivet fragments.

    4. Using a vacuum cleaner, remove the rivet fragments and shavings from the inside of the door.

    5. A01RKDU

      Disengage the 2 guides to remove the front No. 1 speaker assembly.