AUDIO AND VISUAL SYSTEM Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit.

The sound signal that is sent is amplified by the radio and display receiver assembly and then is sent to the speakers.

If there is an open or short in this circuit, sound cannot be heard from the speakers even if the radio and display receiver assembly or speakers are not malfunctioning.

WIRING DIAGRAM

PROCEDURE

1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)

   
   

   1. Disconnect the F31 radio and display receiver assembly connector.

   2. Disconnect the F39 No. 1 stereo jack adapter assembly connector.

   3. 

      *a	Front view of wire harness connector (to Radio and Display Receiver Assembly)
      *b	Front view of wire harness connector (to No. 1 Stereo Jack Adapter Assembly)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection Condition Specified Condition F31-25 (ADPG) - F39-8 (ADPG) Always Below 1 Ω F31-11 (AGND) - F39-9 (AGND) Always Below 1 Ω F31-26 (VAR+) - F39-5 (VAR+) Always Below 1 Ω F31-28 (VAL+) - F39-6 (VAL+) Always Below 1 Ω F31-27 (VA-) - F39-7 (VA-) Always Below 1 Ω F31-25 (ADPG) or F39-8 (ADPG) - Body ground Always 10 kΩ or higher F31-11 (AGND) or F39-9 (AGND) - Body ground Always 10 kΩ or higher F31-26 (VAR+) or F39-5 (VAR+) - Body ground Always 10 kΩ or higher F31-28 (VAL+) or F39-6 (VAL+) - Body ground Always 10 kΩ or higher F31-27 (VA-) or F39-7 (VA-) - Body ground Always 10 kΩ or higher

      Result
      Proceed to OK NG

   
   

   OK

   PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR