AUDIO AND VISUAL SYSTEM Voice Guidance Circuit between Radio Receiver and Stereo Component Amplifier

DESCRIPTION

This circuit is used when the voice switch of the steering pad switch assembly is pushed.

Using this circuit, the radio and display receiver assembly sends signals to the stereo component amplifier assembly.

WIRING DIAGRAM

B004OZWE36
*a (Shielded)
*b Radio and Display Receiver Assembly
*c Stereo Component Amplifier Assembly

PROCEDURE


  1. CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - STEREO COMPONENT AMPLIFIER ASSEMBLY)


    1. Disconnect the F33 radio and display receiver assembly connector.

    2. Disconnect the F61 stereo component amplifier assembly connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester connection Condition Specified condition
      F33-2 (RL+) - F61-15 (II1+) Always Below 1 Ω
      F33-6 (RL-) - F61-14 (II1-) Always Below 1 Ω
      F61-18 (SLD1) - Body ground Always 10 kΩ or higher
      F33-2 (RL+) or F61-15 (II1+) - Body ground Always 10 kΩ or higher
      F33-6 (RL-) or F61-14 (II1-) - Body ground Always 10 kΩ or higher
      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR