STEERING PAD SWITCH REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering pad switch assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects / Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system
Simple intelligent parking assist system
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here

PROCEDURE


  1. REMOVE HORN BUTTON ASSEMBLY

    Click here

  2. REMOVE STEERING PAD SWITCH ASSEMBLY


    1. A01RJFI

      Disconnect 2 connectors from the spiral cable with sensor sub-assembly.

    2. A01RJNG

      Remove the 2 screws.

    3. A01RKNJ

      Disengage the 6 claws and 4 pins to remove the steering pad switch assembly.