PARKING BRAKE CABLE(for Rear Side) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during No. 3 parking brake cable assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Replacement of heated oxygen sensor (w/ Canister Pump Module)

  • Gas leak from exhaust system is repaired

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

w/ Canister Pump Module: Click here

w/o Canister Pump Module: Click here

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.

B004QBP

Tech Tips

Use the same procedure for the No. 2 parking brake cable assembly and No. 3 parking brake cable assembly.

PROCEDURE


  1. LOOSEN NO. 1 WIRE ADJUSTING NUT

    for LHD:

    Click here

    for RHD:

    Click here

  2. REMOVE REAR CONSOLE BOX ASSEMBLY

    Click here

  3. SEPARATE NO. 1 PARKING BRAKE CABLE ASSEMBLY

    Click here

  4. SEPARATE NO. 1 PARKING BRAKE PULL ROD SUB-ASSEMBLY


    1. B004P3W

      Separate the No. 1 parking brake pull rod sub-assembly from the No. 3 parking brake cable assembly as shown in the illustration.

  5. REMOVE FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst)

    Click here

  6. REMOVE FRONT NO. 2 FLOOR HEAT INSULATOR


    1. B004PLS

      Remove the 4 nuts and front No. 2 floor heat insulator.

  7. REMOVE REAR FLOOR SIDE MEMBER COVER LH (for LH Side)

    w/ Canister Pump Module:

    Click here

    w/o Canister Pump Module:

    Click here

  8. REMOVE NO. 1 FLOOR UNDER COVER ASSEMBLY (for RH Side)

    w/ Canister Pump Module:

    Click here

    w/o Canister Pump Module:

    Click here

  9. REMOVE PARKING BRAKE LEVER PROTECTOR


    1. B004OPA

      Remove the parking brake lever protector from the No. 3 parking brake cable assembly.

  10. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY


    1. Remove the 4 bolts and nut, and separate the No. 3 parking brake cable assembly.

      B004OOT
    2. B004OLG

      Pull out the No. 3 parking brake cable assembly to the outside of the vehicle body.

    3. B004QV8

      Separate the No. 3 parking brake cable assembly from the rear disc brake cylinder assembly.

    4. B004PWUC02
      *1 Rear Disc Brake Cylinder Assembly
      *a Clip

      Disengage the clip and remove the No. 3 parking brake cable assembly.