REAR SPEED SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

  • If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

  • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

PROCEDURE


  1. INSTALL REAR AXLE HUB AND BEARING ASSEMBLY


    1. Install the rear axle hub and bearing assembly.

      Click here

      Tech Tips


      • The rear speed sensor is a component of the rear axle hub and bearing assembly. If the rear speed sensor is malfunctioning, replace the rear axle hub and bearing assembly.

      • If the rear speed sensor rotor needs to be replaced, replace the rear axle hub and bearing assembly.

  2. INSPECT REAR AXLE HUB BEARING LOOSENESS

    Click here

  3. INSPECT REAR AXLE HUB RUNOUT

    Click here

  4. INSTALL REAR DISC

    Click here

  5. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

    Click here

  6. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

    Click here

  7. INSTALL PARKING BRAKE LEVER PROTECTOR

    Click here

  8. CONNECT SKID CONTROL SENSOR WIRE


    1. Connect the skid control sensor wire connector to the rear axle hub and bearing assembly.

  9. ADJUST PARKING BRAKE

    Click here

  10. INSTALL REAR WHEEL

    Click here

  11. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL


    1. Connect the cable to the negative (-) auxiliary battery terminal.

      Click here

    2. Connect the reservoir level switch connector.

    3. Turn the power switch on (READY).

    4. Depress the brake pedal and release it.

    5. Clear the DTCs.

      Click here

  12. CHECK FOR SPEED SENSOR SIGNAL

    Click here