ELECTRONICALLY CONTROLLED BRAKE SYSTEM Brake Control Warning Light Remains ON

DESCRIPTION

The skid control ECU (brake booster with master cylinder assembly) is connected to the combination meter assembly via CAN communication.

If the skid control ECU (brake booster with master cylinder assembly) stores a DTC, the brake warning light / yellow (minor malfunction) comes on in the combination meter assembly.

WIRING DIAGRAM

B004PFHE83
*1 CAN Communication Line
*2 Skid Control ECU (Brake Booster with Master Cylinder Assembly)
*3 Combination Meter Assembly (Meter Circuit Plate)

CAUTION / NOTICE / HINT

Note

After replacing the skid control ECU (brake booster with master cylinder assembly), perform linear solenoid valve offset learning, ABS holding solenoid valve learning, yaw rate and acceleration sensor zero point calibration and system information memorization after performing "Reset Memory".

Click here

PROCEDURE


  1. CHECK CAN COMMUNICATION SYSTEM


    1. Check if CAN communication system DTCs are output.

      Click here

      Result
      Result Proceed to
      DTCs are not output. A
      DTCs are output. B

    B

    INSPECT CAN COMMUNICATION SYSTEM Click here

    A

  2. CHECK IF BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY CONNECTOR IS SECURELY CONNECTED


    1. Check if the skid control ECU (brake booster with master cylinder assembly) connector is securely connected.

      OK
      The connector is securely connected.
      Result
      Proceed to
      OK
      NG

    NG

    CONNECT CONNECTOR TO BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY CORRECTLY

    OK

  3. CHECK AUXILIARY BATTERY


    1. Check the auxiliary battery voltage.

      Standard Voltage
      Tester Connection Condition Specified Condition
      Auxiliary battery Power switch on (IG) 11 to 14 V
      Auxiliary battery Power switch on (READY) 11 to 15.5 V
      Result
      Proceed to
      OK
      NG

    NG

    CHARGE OR REPLACE AUXILIARY BATTERY

    OK

  4. READ VALUE USING GTS (BRAKE WARNING LIGHT / YELLOW (MINOR MALFUNCTION))


    1. Select the Data List on the GTS.

      Click here


      Chassis > ABS/VSC/TRC > Data List
      Tester Display Measurement Item Range Normal Condition Diagnostic Note
      ECB Warning Light Brake warning light / yellow (minor malfunction) ON or OFF

      ON: Warning light on

      OFF: Warning light off

      		 ECB: Electronically Controlled Brake System

      Chassis > ABS/VSC/TRC > Data List
      Tester Display
      ECB Warning Light

    2. Check the GTS display condition of the brake warning light / yellow (minor malfunction).

      Result
      Result Proceed to
      ON is displayed. A
      OFF is displayed. B

    A

    REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY for LHD: Click here
    REPLACE BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY for RHD: Click here

    B

    INSPECT METER / GAUGE SYSTEM Click here