FRONT LOWER SUSPENSION ARM(for LH Side) INSTALLATION

PROCEDURE


  1. TEMPORARILY INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH


    1. Temporarily install the front lower No. 1 suspension arm sub-assembly LH to the front suspension crossmember sub-assembly with the 2 bolts and nut.

  2. CONNECT FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH


    1. Connect the front lower No. 1 suspension arm sub-assembly LH to the front lower ball joint assembly LH with the bolt and 2 nuts.

      Torque:
      89 N*m  { 908 kgf*cm, 66 ft.*lbf }

  3. INSTALL FRONT WHEEL

    Click here

  4. STABILIZE SUSPENSION

    Click here

  5. FULLY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH


    1. B004OJ7C01
      *a Torque Wrench Fulcrum Length
      B004OIV Turn

      Using SST, fully tighten the bolt (A).

      SST
      09961-01270
      Torque:
      Specified tightening torque
      240 N*m  { 2447 kgf*cm, 177 ft.*lbf }

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using SST (fulcrum length of 200 mm (7.87 in.)) + torque wrench (fulcrum length of 600 mm (1.97 ft.)):

        180 N*m (1835 kgf*cm, 133 ft.*lbf)

    2. Fully tighten the bolt (B).

      Torque:
      125 N*m  { 1275 kgf*cm, 92 ft.*lbf }

      Note

      Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.

  6. INSTALL REAR MOTOR UNDER COVER LH

    Click here

  7. INSTALL NO. 1 ENGINE UNDER COVER

    Click here

  8. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

    Click here

  9. PERFORM INITIALIZATION

    Intelligent clearance sonar system

    Simple intelligent parking assist system

    Click here

    Parking assist monitor system

    Click here

    Automatic headlight beam level control system

    Click here