FRONT DRIVE SHAFT ASSEMBLY COMPONENTS
ILLUSTRATION
| *A | except Rough Road Area Specification Vehicles | *B | for Rough Road Area Specification Vehicles |
| *1 | NO. 1 ENGINE UNDER COVER | *2 | REAR MOTOR UNDER COVER LH |
| *3 | REAR MOTOR UNDER COVER RH | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT AXLE SHAFT NUT | *2 | FRONT DRIVE SHAFT ASSEMBLY |
| *3 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY | *4 | FRONT SPEED SENSOR |
| *5 | FRONT STABILIZER LINK ASSEMBLY | *6 | TIE ROD END SUB-ASSEMBLY |
| *7 | FRONT FLEXIBLE HOSE | *8 | FRONT AXLE ASSEMBLY |
| *9 | COTTER PIN | - | - |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| ● | Non-reusable part |  |
Do not apply lubricants to the threaded parts |
 |
Toyota Body Grease W | - | - |
ILLUSTRATION
| *1 | FRONT DRIVE SHAFT ASSEMBLY LH | *2 | FRONT DRIVE SHAFT ASSEMBLY RH |
| *3 | FRONT DRIVE SHAFT HOLE SNAP RING | *4 | FRONT DRIVE SHAFT OIL SEAL LH |
| *5 | FRONT DRIVE SHAFT OIL SEAL RH | - | - |
| ● | Non-reusable part | |
ATF WS |
 |
MP grease | - | - |
ILLUSTRATION
| *A | for LH Side | *B | w/ 1 Clamp |
| *C | w/ 2 Clamps | - | - |
| *1 | FRONT AXLE INBOARD JOINT BOOT | *2 | FRONT AXLE INBOARD JOINT BOOT CLAMP |
| *3 | FRONT AXLE OUTBOARD JOINT BOOT | *4 | FRONT AXLE OUTBOARD JOINT BOOT CLAMP |
| *5 | FRONT DRIVE INBOARD JOINT ASSEMBLY | *6 | FRONT DRIVE SHAFT DAMPER |
| *7 | FRONT DRIVE SHAFT DUST COVER | *8 | FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP |
| *9 | FRONT NO. 2 AXLE OUTBOARD JOINT BOOT CLAMP | *10 | SHAFT SNAP RING |
| *11 | TRIPOD JOINT | *12 | FRONT DRIVE OUTBOARD JOINT SHAFT ASSEMBLY |
| *13 | FRONT DRIVE SHAFT DAMPER CLAMP | *14 | FRONT AXLE INBOARD JOINT GROMMET |
| ● | Non-reusable part | - | - |
ILLUSTRATION
| *A | for RH Side | *B | w/ 1 Clamp |
| *C | w/ 2 Clamps | - | - |
| *1 | FRONT AXLE INBOARD JOINT BOOT | *2 | FRONT AXLE INBOARD JOINT BOOT CLAMP |
| *3 | FRONT DRIVE INBOARD JOINT ASSEMBLY | *4 | FRONT DRIVE SHAFT DAMPER |
| *5 | FRONT DRIVE SHAFT DUST COVER | *6 | FRONT NO. 2 AXLE INBOARD JOINT BOOT CLAMP |
| *7 | SHAFT SNAP RING | *8 | TRIPOD JOINT |
| *9 | FRONT DRIVE OUTBOARD JOINT SHAFT ASSEMBLY | *10 | FRONT DRIVE SHAFT DAMPER CLAMP |
| *11 | FRONT AXLE INBOARD JOINT GROMMET | - | - |
| ● | Non-reusable part | - | - |