MOTOR CABLE REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during motor cable removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Auxiliary battery terminal is disconnected/reconnected Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Intelligent clearance sonar system*1
Simple intelligent parking assist system*1
Pre-crash safety system
Parking assist monitor system

Click here

Initialize back door lock Power door lock control system

Click here


    for SFI system (w/ Canister Pump Module)

  • Replacement of ECM

 Perform Vehicle Identification Number (VIN) registration MIL comes on

Click here


    for SFI system (w/o Canister Pump Module)

  • Replacement of ECM

 Perform Vehicle Identification Number (VIN) or frame number registration MIL comes on

Click here

Replacement of inverter with converter assembly Resolver learning

  • DTCs are stored

  • Slight vibration at a vehicle speed of 5 km/h (3 mph) or less

  • Shock or vibration during acceleration

Click here

*1: When performing learning using the GTS.
Click here Click here

CAUTION:


  • B004PF2

    Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.

    Click here

  • B004Q03

    To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.

PROCEDURE


  1. REMOVE INVERTER WITH CONVERTER ASSEMBLY

    Click here

  2. REMOVE MOTOR CABLE

    CAUTION:

    Be sure to wear insulated gloves.


    1. A01RI5J

      Remove the 2 bolts and connector cover from the hybrid vehicle transaxle assembly.

    2. A01RK7Z

      Disengage the 2 claws to remove the terminal cap from the hybrid vehicle transaxle assembly.

    3. A01RIH3C01
      *a Waterproof Seal

      Using an insulated tool, remove the 6 bolts and motor cable from the hybrid vehicle transaxle assembly.

      Note


      • Keep the motor cable terminals and their installation area free from foreign matter, water, etc.

      • Do not touch the waterproof seal or terminals of the motor cable.

      • Cover the hole where the motor cable was installed with tape or equivalent (non-residue type) to prevent entry of foreign matter.