ELECTRONIC SHIFT LEVER SYSTEM "P" Position Switch Circuit

PROCEDURE


  1. CHECK DIAGNOSIS RELATED INFORMATION (HYBRID CONTROL)


    1. Check for diagnosis related information.

      Click here

      Result
      Result Proceed to
      No diagnosis related information is output. A
      The diagnosis related information in the table below is output. B
      Diagnosis Related Information
      P085011
      P085015

    A
    B
  2. CHECK CONNECTOR CONNECTION CONDITION (HYBRID VEHICLE CONTROL ECU CONNECTOR)


    1. Check the connector connections and contact pressure of the relevant terminals for the hybrid vehicle control ECU connectors.

      Click here

      B004P9FC01
      *A for LHD *B for RHD
      OK
      The connectors are connected securely and there are no contact pressure problems.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  3. CHECK CONNECTOR CONNECTION CONDITION (P POSITION SWITCH (TRANSMISSION SHIFT MAIN SWITCH) CONNECTOR)


    1. Check the connector connections and contact pressure of the relevant terminals for the P position switch (transmission shift main switch) connector.

      Click here

      OK
      The connector is connected securely and there are no contact pressure problems.
      Result
      Proceed to
      OK
      NG

    NG
    OK
  4. CHECK DTC OUTPUT (HYBRID CONTROL)


    1. Connect the GTS to the DLC3.

    2. Turn the power switch on (IG).

    3. Jiggle the connectors and wire harness that connect the P position switch (transmission shift main switch) to the P1 terminal of the hybrid vehicle control ECU up and down, and left and right.

    4. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.


      Powertrain > Hybrid Control > Trouble Codes
    5. Check for DTCs.

      Result
      Result Proceed to
      DTCs are not output. A
      DTCs are output. B
    6. Turn the power switch off.


    A
    B