MILLIMETER WAVE RADAR SENSOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar sensor assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Millimeter wave radar sensor assembly Adjust millimeter wave radar sensor assembly

  • Dynamic radar cruise control system

  • Pre-crash safety system

  • Forward recognition camera system

  • Lane departure alert system (w/ Steering Control System)

  • Road sign assist system

Click here

PROCEDURE


  1. REMOVE RADIATOR SUPPORT OPENING COVER

    Click here

  2. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY


    1. A01RIUZ

      Disconnect the connector.

    2. A01RIX3C01
      B004PRK Bolt
      B004P9H Screw

      Remove the 2 bolts and 2 screws.

    3. Disengage the 2 guides and remove the millimeter wave radar sensor assembly.

      Note

      Do not reuse the millimeter wave radar sensor assembly if it has been dropped or subjected to a severe impact.