ROAD SIGN ASSIST SYSTEM TERMINALS OF ECU


  1. CHECK FORWARD RECOGNITION CAMERA

    Note


    • DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.

    • Do not apply excessive force to the O7 forward recognition camera connector.

    A003PGSE47

    1. Disconnect the O7 forward recognition camera connector.

    2. Measure the voltage and resistance according to the value(s) in the table below.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      O7-7 (IGB) - O7-10 (GND) LG - W-B Power source Power switch on (IG) 11 to 14 V
      Power switch off Below 1 V
      O7-10 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

    3. Reconnect the O7 forward recognition camera connector.

    4. Check for pulses according to the value(s) in the table below.

      Tech Tips

      If the waveform is not similar to that shown in the illustration, a malfunction of a CAN bus line, terminating resistor, or the forward recognition camera is suspected.

      Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition
      O7-5 (CA1P) - O7-10 (GND) GR - W-B CAN communication signal Power switch on (IG)

      Pulse generation

      (See waveform 1)
      O7-11 (CA1N) - O7-10 (GND) W - W-B CAN communication signal Power switch on (IG)

      Pulse generation

      (See waveform 2)
      O7-6 (CANH) - O7-10 (GND) G - W-B CAN communication signal Power switch on (IG)

      Pulse generation

      (See waveform 1)
      O7-12 (CANL) - O7-10 (GND) W - W-B CAN communication signal Power switch on (IG)

      Pulse generation

      (See waveform 2)

      1. A003PJLE97
        *a 1 V/DIV.
        *b 10 μsec./DIV.

        WAVEFORM 1

        Item Content
        Terminal Name

        Between O7-5 (CA1P) and O7-10 (GND)

        Between O7-6 (CANH) and O7-10 (GND)
        Tester Range 1 V/DIV., 10 μsec./DIV.
        Condition Power switch on (IG)

        Tech Tips

        The waveform varies depending on the CAN communication signal.

      2. A003PJ4E89
        *a 1 V/DIV.
        *b 10 μsec./DIV.

        WAVEFORM 2

        Item Content
        Terminal Name

        Between O7-11 (CA1N) and O7-10 (GND)

        Between O7-12 (CANL) and O7-10 (GND)
        Tester Range 1 V/DIV., 10 μsec./DIV.
        Condition Power switch on (IG)

        Tech Tips

        The waveform varies depending on the CAN communication signal.