INTELLIGENT CLEARANCE SONAR SYSTEM, Diagnostic DTC:C1A50

DTC Code DTC Name
C1A50 Brake System

DESCRIPTION

When an electronically controlled brake system malfunction signal sent from the skid control ECU assembly is detected by the clearance warning ECU assembly, DTC C1A50 is stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
C1A50 Brake System When the power switch is on (IG), a VSC warning light malfunction signal is detected for 1 second or more.

  • Electronically controlled brake system

  • Clearance warning ECU assembly

CAUTION / NOTICE / HINT

Note


  • After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work.

    Click here

  • After replacing an ultrasonic sensor or the clearance warning ECU assembly, perform the necessary procedures (adjustment, calibration, initialization or registration).

    Click here

PROCEDURE


  1. CHECK DTC


    1. Using the GTS, check for DTCs according to the prompts on the screen.


      Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes
      Result
      Proceed to
      NEXT

    NEXT

  2. CLEAR DTC


    1. Clear the DTCs.


      Body Electrical > IPA/ICS/Clearance Sonar > Clear DTCs
      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK DTC OUTPUT


    1. Recheck for DTCs and check if the same DTC is output again.


      Body Electrical > IPA/ICS/Clearance Sonar > Trouble Codes

      Tech Tips


      • DTC C1A50 is stored when a malfunction signal sent from the electronically controlled brake system is detected.

      • If the malfunctioning part has been repaired or replaced before rechecking for DTCs, DTC C1A50 will not be output again.

      • If DTC C1A50 is output frequently, duplicate the conditions that cause the problem symptoms and perform the inspection again, even though the DTC was not output when rechecking for DTCs.

        Click here

      Result
      Result Proceed to
      C1A50 is output A
      C1A50 is not output B

    A

    GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM Click here

    B

    USE SIMULATION METHOD TO CHECK Click here