COOLING FAN MOTOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during cooling fan motor LH or cooling fan motor RH removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly

  • Ultrasonic sensor detection angle (w/ TOYOTA Parking Assist-sensor System)

  • Ultrasonic sensor detection angle registration (w/ TOYOTA Parking Assist-sensor System)

  • Intelligent clearance sonar system

  • Simple advanced parking guidance system

Click here

Change grille shutter control modes and/or perform initialization (w/ Exhaust Heat Recirculation System) Grille Shutter system

Click here

PROCEDURE


  1. REMOVE RADIATOR ASSEMBLY

    Click here

  2. REMOVE FAN RH


    1. A01RKJ6

      Remove the nut and fan RH.

  3. REMOVE FAN LH


    1. A01RJRE

      Remove the nut and fan LH.

  4. REMOVE COOLING FAN MOTOR RH


    1. A01RI4X

      Remove the 3 screws and cooling fan motor RH.

  5. REMOVE COOLING FAN MOTOR LH


    1. A01RLIMC01
      *A Cooling Fan Motor 120 W Type
      *B Cooling Fan Motor 160 W Type

      Disengage the 3 clamps.

    2. A01RL09

      Remove the 3 screws and cooling fan motor LH.