TEMPERATURE SWITCH REMOVAL

PROCEDURE


  1. REMOVE REAR MOTOR UNDER COVER LH

    Click here

  2. DRAIN ENGINE COOLANT (for Engine)

    Click here

  3. REMOVE FRONT WIPER MOTOR AND LINK ASSEMBLY

    Click here

  4. REMOVE NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)

    Click here

  5. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)

    Click here

  6. REMOVE WATER GUARD PLATE LH

    Click here

  7. REMOVE COWL BODY MOUNTING REINFORCEMENT LH

    Click here

  8. REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY

    Click here

  9. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A01VC2V

      Disconnect the engine coolant temperature sensor connector.

    2. A01VC9P

      Using a 19 mm union nut wrench, remove the engine coolant temperature sensor from the No. 2 water joint.

      Note

      Do not apply any excessive force to the heater pipe when removing the engine coolant temperature sensor.