TEMPERATURE SWITCH INSTALLATION

PROCEDURE


  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR


    1. B004PPHC01
      *a Torque Wrench Fulcrum Length

      Using a 19 mm union nut wrench, install the engine coolant temperature sensor to the No. 2 water joint.

      Torque:
      Specified tightening torque
      8.0 N*m  { 82 kgf*cm, 71 in.*lbf }

      Note

      Do not apply any excessive force to the heater pipe when installing the engine coolant temperature sensor.

      Tech Tips


      • Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.

        Click here

      • When using a 19 mm union nut wrench (fulcrum length of 30.0 mm (1.18 in.)) + torque wrench (fulcrum length of 155 mm (6.10 in.)): 7.0 N*m (71 kgf*cm, 62 in.*lbf)

    2. Connect the engine coolant temperature sensor connector.

  2. INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY

    Click here

  3. INSTALL COWL BODY MOUNTING REINFORCEMENT LH

    Click here

  4. INSTALL WATER GUARD PLATE LH

    Click here

  5. INSTALL NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)

    Click here

  6. INSTALL NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)

    Click here

  7. INSTALL FRONT WIPER MOTOR AND LINK ASSEMBLY

    Click here

  8. ADD ENGINE COOLANT (for Engine)

    Click here

  9. INSPECT FOR COOLANT LEAK (for Engine)

    Click here

  10. INSTALL REAR MOTOR UNDER COVER LH

    Click here