FUEL TANK PRESSURE SENSOR(w/ Canister Pump Module) REMOVAL

PROCEDURE


  1. REMOVE REAR SEAT CUSHION ASSEMBLY

    Click here

  2. REMOVE REAR SEAT CUSHION LOCK HOOK

    Click here

  3. REMOVE NO. 3 WIRING HARNESS PROTECTOR

    Click here

  4. REMOVE REAR FLOOR SERVICE HOLE COVER

    Click here

  5. REMOVE FUEL TANK PRESSURE SENSOR (VAPOR PRESSURE SENSOR)


    1. A01RI0UC01
      *1 Fuel Tank Pressure Sensor (Vapor Pressure Sensor)
      *2 Fuel Suction Plate Sub-assembly
      *3 Tube Joint Clip
      *a O-ring

      Remove the tube joint clip and pull off the fuel tank pressure sensor (vapor pressure sensor) from the fuel tank assembly.

      Note


      • Remove any dirt or foreign matter on the fuel tank pressure sensor (vapor pressure sensor) before performing this work.

      • Do not allow any scratches or foreign matter to get on the parts when disconnecting them as the fuel tank pressure sensor (vapor pressure sensor) has an O-ring that seals the fuel suction plate sub-assembly.

      • Perform this work by hand. Do not use any tools.

      • If the fuel suction plate sub-assembly and fuel tank pressure sensor (vapor pressure sensor) are stuck, carefully wiggle or push and pull the fuel tank pressure sensor (vapor pressure sensor) to release it. Pull the fuel tank pressure sensor (vapor pressure sensor) off the fuel suction plate sub-assembly carefully.