EGR VALVE COMPONENTS
ILLUSTRATION
| *1 | BATTERY SERVICE HOLE COVER | *2 | SERVICE PLUG GRIP |
ILLUSTRATION
| *A | except Rough Road Area Specification Vehicles | *B | for Rough Road Area Specification Vehicles |
| *1 | REAR MOTOR UNDER COVER LH | - | - |
ILLUSTRATION
| *A | for LHD | - | - |
| *1 | COWL BODY MOUNTING REINFORCEMENT LH | *2 | NO. 1 HEATER AIR DUCT SPLASH SHIELD SEAL |
| *3 | OUTER COWL TOP PANEL SUB-ASSEMBLY | *4 | WATER GUARD PLATE LH |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |  |
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
| *A | for RHD | - | - |
| *1 | COWL BODY MOUNTING REINFORCEMENT LH | *2 | NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL |
| *3 | OUTER COWL TOP PANEL SUB-ASSEMBLY | *4 | WATER GUARD PLATE LH |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
| *1 | AIR CONDITIONING WIRE | *2 | BATTERY CLAMP SUB-ASSEMBLY |
| *3 | CONNECTOR COVER ASSEMBLY | *4 | ENGINE WIRE |
| *5 | HV FLOOR UNDER WIRE | *6 | INVERTER WITH CONVERTER ASSEMBLY |
| *7 | NO. 1 ENGINE COVER SUB-ASSEMBLY | *8 | NO. 1 RELAY BLOCK COVER |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
| *1 | EGR PIPE ASSEMBLY | *2 | EGR VALVE ASSEMBLY |
| *3 | INLET EGR GASKET | *4 | EGR PIPE GASKET |
| *5 | NO. 6 WATER BY-PASS HOSE | *6 | WATER BY-PASS HOSE |
| *7 | EGR VALVE GASKET | *8 | STUD BOLT |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |